Warranty - Craftsman 580.752840 Operator's Manual

2-1N-1 Soap System
The pressure washer is equipped with two detergent
siphoning tubes.
Project Pro PerfectMix
TM
Siphon
Blue tube with blue bottle cap:
When using the blue PerfectMix
TM
siphon, use
the PerfectMix
TM
Extreme Concentrate straight
from the bottle.
Add Engine Oil
1. Place pressure washer on a fiat, level surface.
2. Cleanarea around oil fill and remove yellow oil fill cap.
3. Using oil funnel (optional), slowly pour contents of
supplied oil into oil fill opening (E), frequently checking
oil level. DO NOT OVERFILL.
Standard Siphon Tube
Cleartube with filter:
When using the clear siphon tube, dilute
1 part PerfectMix
TM
Extreme Concentrate
to 16 parts water (4 oz of concentrate
makes 1/2 gallon of mix.)
Attach ProjectPro@PerfectiVlix
TM
Siphon to
Pump
Attach the tube end of the blue PerfectMix
TM
Siphon (A) to
the barbed hose fitting (B) on the pump.
Attach PerfectlVlix
TM
DetergentSiphon to
Concentrate Bottle
Place PerfectMix
TM
bottle (not included) in the wire-form
bracket on the handle. Remove cap from bottle and insert the
PerfectMix
TM
Siphon (C). Screw the siphon unit to the top of
the bottle (D). Use the clip on the cap (C) to snap siphon to
wire form bracket when siphon is not in a concentrate bottle.
NOTICE improper treatment of pressure washer could
damage it and shorten its life.
• DO NOT attempt to crank or start the engine before it has been
properly serviced with the recommended oil. This could result in
an engine failure.
4. Replaceoil fill cap and fully tighten.
Add Fuel
Fuel must meet these requirements:
• Clean,fresh, unleaded gasoline.
• A minimum of 87 octane/87 AKI (91 RON). High altitude
use, see High Altitude.
• Gasolinewith up to 10% ethanol (gasohol) or up to 15%
MTBE (methyl tertiary butyl ether) is acceptable.
NOTICE Avoid pressure washer damage.
Failureto follow Operator's Manual for fuel
recommendations voids warranty.
• DONOTuseunapproved g asolinesuchas E85.
• DONOTmix oil in gasoline.
• DONOTmodifyengineto run on alternate fuels.
,A WARNING Fueland its vapors are extremelyflammable
and explosivewhich could causeburns,
fire or explosion resulting in death,
serious injury and/or property damage.
WHEN ADDINGFUEL
• Turn pressure washer engine OFFand let it cool at least 2
minutes before removing fuel cap. Loosen cap slowly to relieve
pressure in tank.
• Fill fuel tank outdoors.
• DO NOT overfill tank. Allow spacefor fuel expansion.
• If fuel spills, wait until it evaporatesbefore starting engine.
• Keepfuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
• Checkfuel lines, tank, cap and fittings frequently for cracks or
leaks. Replaceif necessary.
• DO NOT light a cigarette or smoke.