Da2100/2200 Os/2 Driver Command-Line Options - Asus PCI-DA2100 User Manual

Appendix A
2. Shutdown OS/2, then restart your computer.
5.4

DA2100/2200 OS/2 Driver Command-Line Options

1. Driver Command Syntax :
BASEDEV=DA2000.ADD [Driver-Options][Adapter-
Options][Unit-Options]
The command and options must be put in the CONFIG.SYS file. The
changes of command-line option will not take effect until the system
is restarted.
2. Command-Line Options :
1). Command-line options are case-insensitive.
2). All command-line options begin with the slash character (/).
3). The exclamation character (!) is a negation operator; that is, it
negates the option that follows it.
3. Driver-Options :
/V
Verbose. Either Display the driver name, version number, date,
adapter Information and device information if the driver loads
successfully, or display error messages if the driver fails to initialize.
/(!)ET
(Disable) Enable Embedded Target Support. Makes the driver
(disable) enable not-zero SCSI LUN support. Default setting is /ET.
/PCI:n
Maximum PCI Bus Number in the computer. Where n is a decimal
value between 0 to 255. Default value is 255.
4. Adapter-Options :
/A:n
Adapter Identification. where n is a decimal value. This option
specifies the ordering of adapters. Normally, adapters are numbered
consecutively, starting at 0.
166
ASUS PCI-DA2100/PCI-DA2200 User's Manual