Appliance Self-Test; Troubleshooting - Bosch B18IW Series Use & Care Manual

Low voltage
The display light has gone out.
Cause
The mains voltage has dropped
below the permitted limit value.
Remedial action
Buttons cannot be pressed. When
the mains voltage reaches the
stipulated value again, the warning
message goes out. If the warning
message is prolonged, inform your
power supply company.
Appliance
self-test
Before you call customer service,
conduct an appliance self test.
C3 Switch off the appliance and
wait 5 minutes. Keep the door
closed.
C3 Switch on the appliance.
setup
C3 Simultaneously hold down the
setup and alarm off buttons for
5 seconds.
The self test starts. Different
messages are display in succession.
If a fault is detected during the
self test, the ALARM symbol and
a corresponding error message,
e.g. for a sensor fault, are displayed.
Inform customer service about the
error message.
If the appliance self test does not
establish any faults, the required
temperature is displayed on
completion of the self test.
Troubleshooting
Fault Possible cause Remedial action
Appliance has no cooling capacity. Power failure; the fuse has actuated; Checkthat the power is on. The fuse must be switched
The interior light does not function, the mains plug is not in properly, on. Checkthat the mains plug is plugged in.
The display does not come on.
The refrigerating unit switches on
more and more frequently and for
longer.
The temperature in the both
compartments is too cold.
The interior light does not function.
Appliance door opened frequently.
The ventilation openings are covered.
Temperature has been set too tow.
The bulb is defective.
The light switch is sticking.
Do not open the door unnecessarily.
Removeobstacles and dirt.
Set a warmer temperature (see "Setting the
temperature").
Changethe bulb (see "Changingthe bulb").
Check whether it can be moved.
16