Advertisement
Quick Links
Continuous Ink Supply System
Epson Stylus Photo R200/R210/R300/R310
Installation Instruction
This Version of the Continuous Ink Flow System comes with Prefilled Cartridges and
Auto Reset Chips. You just need to fill the Reservoir bottles and print! The whole
operation is very easy. It's really an effective tool to save your money.
for
For ST Prefilled Version
With Auto Reset Chips
Advertisement
Related Manuals for Epson Continuous Ink Supply System
Summary of Contents for Epson Continuous Ink Supply System
- Page 1 Continuous Ink Supply System Epson Stylus Photo R200/R210/R300/R310 Installation Instruction For ST Prefilled Version With Auto Reset Chips This Version of the Continuous Ink Flow System comes with Prefilled Cartridges and Auto Reset Chips. You just need to fill the Reservoir bottles and print! The whole...
-
Page 2: General Guide
CIS for EPSON stylus R200/R210/R300/R310 Instruction Thank you for purchasing ST Continuous Ink Supply System. We appreciate your support and will try our best to make your experience with our products a pleasant one. Printing has been a different experience ever since you installed ST Continuous Ink Supply system on your own printer. -
Page 3: Installation Procedures
2) Print testing lines to ensure the printing head is good condition. 3) Print pictures to see whether the printing image is ok. 3、Installation Procedures: 1) First step Put the CISS on the left side Pull out the small rubber plug Place 4pcs of air filters into of the printer. - Page 4 Circumgyrate screwdreiver Separate the right side of Take off the cover of cartridge-car deasilly cartridge-car 4) Fourth step: Set up the Continuous Ink Supply System Remove original cartridge Insert our no-sponge cartridge Close the cover for cartridge into printer carefully 5) Fiveth step: Fix Support Arm Tear off the sticker Fix the arm on the 25cm right far from...
- Page 5 6) Sixth step : Install tubeline Insert tubelline through the arm Finished 7) Seventh Step: Adjust the tubeline Adjust the tubeline,remove the Make sure tubline will not meet Make sure the lengh of tubline is Cartridge-car back and forth printer when printing enough to reach the far left and right Too long twist...
-
Page 6: Reset Procedure
9)Nineth step: Nozzle check Usual Broken line 进入打印机喷嘴检查选项 The nozzle check patterns are in broken-line, mostly because of small dusk entered into the nozzle, after repeated cleaning, if there is still a few broken line, pls let the printer don’t work about 1 hour, then print the nozzle check pattern, maybe it works well. - Page 7 Please pay attention to the ink level in the reservoirs; if the ink level is below 1CM as the above picture shown, please use refill kits to fill ink into Reservoir bottles. Carefully pull out the rubber plugs from the refill holes.(there is possibility of ink spattering. Be careful!) Refill ink according to the color in short supply.
- Page 8 Keep the reservoir bottles on the same level with the printer. 2. Try to keep at least 1/2 inch of ink in the bottles, as you don’t want to run out of ink and draw air into the cartridge. 3. Don’t place the Reservoir Bottles higher or lower much than the printer. 4.