Sony KDL-32W600A Instruction & Operation Manual page 3

Press "/1 on the TV to turn it off, disconnect
the AC power cord (mains lead), and inform
your dealer or Sony service centre of how the
indicator flashes (number of flashes).
Also refer to "Troubleshooting" in the
i-Manual. If the problem persists, have your
TV serviced by qualified service personnel.
 Check the antenna (aerial)/cable connection.
 Connect the TV to the AC power (mains), and
press "/1 on the TV or remote.
 Check the antenna (aerial) or dish.
For satellite models only:
 The satellite cable might be short-circuited or
there might be connection problems of the
cable. Check the cable connection and then turn
the TV off with the Mains power On/Off switch,
and turn it on again.
 The frequency that you entered is out of range.
Consult the received satellite broadcasting
company.
 Check the cable connection or tuning
configuration.
 Attempt the "Digital Auto Tuning" by selecting
"Antenna" instead of "Cable".
 Replace the batteries.
 Your TV may be in SYNC mode.
Press , select "TV Control" and then
select "Home (Menu)" or "Options" to control
the TV.
 Enter 9999 for the PIN code. (PIN code 9999 is
always accepted.)
 When the TV is used for an extended period, the
TV surrounds become warm.
You may feel hot when touching there by the
hand.
 Perform a simple reset of the TV by unplugging
the AC power cord for two minutes, then plug it
in again.

"/1
 See below illustration for location of the buttons
on the TV.
Rear of TV
 If you do not wish to light up the illumination
LED, you can turn it off.
Press , then select "Settings" t "System
Settings" t "General Set-up" t "Illumination
LED" t "Off". You can also press
then select "Illumination LED" t "Off".
GB
    
,
GB