Rear Socket And Scart Details - Hitachi 42PD3000 User Manual

audio output (RCA)
These sockets can be
used to connect to
external amplifier or Hi-Fi
system.
AUDIO VISUAL CONTROL
(AVC) UNIT
VIDEO OUT
Y
AUDIO OUT
C
S-VHS B
L
P
R
C
B
R
P
R
FMS5011
AV4 component input
video broadcasting equipment,
home entertainment systems
and DVD players etc. to your
RF aerial socket
This should be permanently
connected to an RF source -
i.e your aerial antenna.
Mains Socket
This should be connected
to the Mains Supply via
the supplied Mains Lead.
SubWoofer
This socket can be used
to connect a SubWoofer
speaker.*
*If this product is used with an active SubWoofer, it is possible to change its frequency by
adjusting the LPF (Low Pass Filter) control on the Subwoofer speaker. This will enable you to
important note on installation
If you intend placing this TV into a cabinet or wall alcove, please ensure there is at least a
100mm (10cm) gap to the sides, rear and top of the television. This is to allow for adequate
Do not allow soft furnishings, such as curtains to be draped over the TV whilst in operation.
Never place the TV onto a carpet during normal operation - this could obstruct ventilation slots
Always place the TV on a flat surface, or if supplied, the stand accessory.
Failure to observe the above guidelines could result in serious overheating of your TV, or even, in
VGA input
Use this to connect to
your computer if
desired.
CENTER
AUDIO IN
L
R
Use this to connect digital
TV.
Output sockets (S-VHS monitor out & video out)
These sockets can be used to connect to external equipment to
supply a picture only, (no menus or Text), e.g. to a video projector.
PLASMA SCREEN
Link Sockets
These should be
connected to your
AVC Unit via the link
lead.
select the most suitable sound performance.
extreme cases, fire.
Link Sockets
These should be
connected to your
plasma screen via the
link lead.
AV2·AV3scart input
Use this to connect digital
video broadcasting equipment
and home entertainment
systems to your TV. for RGB
input
S-VHS out is not available when receiving
SECAM signal, AV4 and S-VHS input
Use this button if you wish to test the functionality of the
plasma screen without the AVC unit being attached.
Press and hold this button for more than 5 seconds and a
test picture will be displayed on the screen.
ventilation.
on the base of the TV.
Mains Socket
This should be connected
to the Mains Supply via
the supplied Mains Lead.
AV1 scart input
Use this socket to
connect ordinary VHS,
S-VHS or Hi8
equipment to your TV.
(Connect VCR to AV1
for Viewlink).
test button
7