Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZDT6453
Summary of Contents for Zanussi ZDT6453
- Page 1 GESCHIRRSPÜLER DISHWASHER ZDT 6453 Bedienungsanleitung Instruction book...
-
Page 2: Table Of Contents
Contents Safety instructions Installation instructions Building-in Disposal Levelling Fixing to the adjacent units Economical end ecological dishwashing Water supply connections Description of the appliance Water inlet hose with safety valve Water outlet hose connection The control panel Electrical connection Prior to using for the first time Hints for test centres Setting the water softener Filling with salt... -
Page 3: Safety Instructions
Safety instructions It is most important that this instruction book should be Under no circumstances should you attempt to repair the retained with the appliance for future reference. Should machine yourself. Repairs carried out by inexperienced the appliance be sold or transferred to another owner, or persons may cause injury or serious malfunctioning. -
Page 4: Description Of The Appliance
Description of the appliance Upper basket stop Water hardness switch Salt container Detergent dispenser (type A / type B) Control panel Rating plate Rinse aid dispenser (type A / type B) Filters Lower spray arm 10. Upper spray arm 11. Upper basket IN143 The control panel Function push buttons:... -
Page 5: Prior To Using For The First Time
Audible signals 3. Press the function push button 3, the indicator lights of function push buttons 1 and 2 turn off while the indicator Audible signals have been introduced to help indicate which light of the push button 3 goes on flashing, at the same time operations the dishwasher is performing: the "end of programme"... -
Page 6: Filling With Salt
Setting electronically Filling with salt The dishwasher is factory set at level 5. If it’s necessary to set a new level, proceed as follows. Special salt can be added in one of two ways: If you are using dishwasher detergent that already contains 1. -
Page 7: Rinse Aid
Rinse aid Filling with rinse aid (Rinse aid dispenser type B) Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The 1. Open the container by turning the lid (A) anticlockwise. dispenser, which is positioned inside the door, holds about 110 2. -
Page 8: In Daily Use
3. Press the function push button 2, the indicator lights of Deactivation of the inflow of rinse aid function push buttons 1 and 3 turn off while the indicator (The dishwasher must be switched off) light of the push button 2 goes on flashing, at the same time the "end of programme"... -
Page 9: The Upper Basket
Cutlery should be placed in the removable cutlery basket with Adjusting the height of the upper basket the handles facing downwards. If the handles protrude from If washing very large plates you can load them in the lower the bottom of the basket, obstructing the lower spray arm, load basket after moving the upper basket to the higher position. -
Page 10: Use Of Detergent
Use of detergent Use of "3 in 1" combi detergent tablets Only use detergents specifically designed for use in General advice dishwashers. These products are tablets with combined detergent/rinse-aid Using no more then the correct amount of detergent and salt functions. contributes to reducing pollution. -
Page 11: Washing Programmes
Washing programmes Programme Degree of soil Press the Cycle (3) Consumption values programme description Programme duration Energy Water type of load button (in minutes) consumption consumption (in kWh) (in litres) Hot prewash Heavy soil. Main wash up to 70°C Intensive 70° 2 warm rinses Crockery, cutlery, 85 - 95... -
Page 12: Starting A Washing Programme
Starting a washing programme In this fully integrated appliance the controls are located on the 6. Setting/cancelling the "delay start" top of the door. When selecting a programme, the door needs The setting of the delay start occurs after selecting to be open. -
Page 13: Maintenance And Cleaning
Maintenance and cleaning Clean the external surfaces of the machine and control panel To ensure a correct with a damp soft cloth. If necessary use only neutral working of the dishwasher, detergents. Never use abrasive products, scouring pads or NEVER try to remove the solvent (acetone, trichloroethylene etc..). -
Page 14: What To Do, When
What to do, when... Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer..a flashing fault code appears The dishwasher will not start or stops during operation. All push buttons are inoperative except for the On/Off push button. The intervention of an alarm is indicated by a combination of flashing indicator lights and audible signals, as indicated in the following chart Open the door, press the On/Off push button to switch the dishwasher off and carry out the following suggested corrective actions. -
Page 15: Service And Spare Parts
...the wash results are not satisfactory The dishes are not clean The wrong washing programme has been selected. The dishes were arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded. The spray arms do not rotate freely due to wrong arrangement of the load. -
Page 16: Installation Instructions
Installation instructions Any electrical and/or plumbing work required to install Do not use, for connection, old hoses which have been this appliance should be carried out by a qualified used in another appliance. electrician and/or plumber or competent person. If the machine is connected to new pipes or pipes which have Remove all packaging before positioning the machine. -
Page 17: Water Outlet Hose Connection
Water outlet hose connection Electrical connection The end of the drain hose can be connected in the following Information concerning the electrical connection is given on the ways: rating plate on the edge of the dishwasher’s door on the right. 1. -
Page 18: Hints For Test Centres
Hints for test centres Testing in accordance with EN 60704 must be carried out with appliance fully loaded and using the test programme (see "Washing programmes" chart). Test in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see "Washing programmes"... - Page 19 From the Electrolux Group. The world’s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx.