Network; Ip Address; Mac Address Filter - Yamaha RX-V673 Owner's Manual

Network

Configures the network settings.
■

IP Address

Configures the network parameters (such as IP address).
❑ DHCP
Select whether to use a DHCP server.
Settings
Does not use a DHCP server. Configure the network parameters
Off
manually. For details, see "Manual network settings".
Uses a DHCP server to automatically obtain the unit's network
On (default)
parameters (such as IP address).
■
Manual network settings
1
Set "DHCP" to "Off".
2
Use the cursor keys (q/w) to select a parameter type and press ENTER.
IP Address Specifies an IP address.
Subnet Mask Specifies a subnet mask.
Default Gateway Specifies the IP address of the default gateway.
DNS Server (P) Specifies the IP address of the primary DNS server.
DNS Server (S) Specifies the IP address of the secondary DNS server.
3
Use the cursor keys (e/r) to move the edit position and the cursor keys (q/w) to
select a value.
4
To confirm the setting, press ENTER.
5
To configure another network parameter, repeat steps 2 to 4.
6
To save the changes, use the cursor keys to select "OK" and press ENTER.
7
To exit from the menu, press ON SCREEN.
■
Network Standby
Selects whether the unit can be turned on from other network devices (network
standby).
Settings
Off (default) Disables the network standby function.
Enables the network standby function.
On
(The unit consumes approximately 2 W of power.)
■

MAC Address Filter

Sets the MAC address filter to limit access to the unit from other network devices.
❑ Filter
Enables/disables the MAC address filter.
Settings
Off (default) Disables the MAC address filter.
Enables the MAC address filter. In "MAC Address 1–10", specify the
On MAC addresses of the network devices that will be permitted access
to the unit.
❑ MAC Address 1–10
Specifies the MAC addresses (up to 10) of the network devices that will be permitted
access to the unit when "Filter" is set to "On".
■
Procedure
1
Use the cursor keys (q/w) to select "MAC Address 1–5" or "MAC Address 6–10"
and press ENTER.
2
Use the cursor keys (q/w) to select an MAC address number and press ENTER.
3
Use the cursor keys (e/r) to move the edit position and the cursor keys (q/w) to
select a value.
4
To confirm the setting, press ENTER.
5
To save the changes, use the cursor keys to select "OK" and press ENTER.
6
To exit from the menu, press ON SCREEN.
CONFIGURATIONS ➤ Configuring various functions (Setup menu)
98
En