Brother NX-2000 Operation Manual page 60

SEWING THE STITCHES
d
Grasp the bobbin case, and then pull it out.
a Bobbin case
e
Use the disc-shaped screwdriver included
with the machine to unscrew and remove the
regular needle plate.
f
Set the straight stitch needle plate in place
and use the screwdriver to tighten the plate.
Note
Align the two screw holes on the needle plate with the
two holes on the machine. Use the disc-shaped
screwdriver to tighten the screws in the needle plate.
58
g
Insert the bobbin case so that the
aligns with the mark as shown below, and
then attach the needle plate cover.
a
mark
b
mark
* Align the and marks.
h
After reinstalling the needle plate cover,
select one of the following straight stitches.
1
Memo
When using the straight stitch needle plate, all straight
stitches become middle needle position stitches. You
cannot change the needle position using the width
display.
CAUTION
• Selecting other stitches will cause an error message
to be displayed.
• Be sure to turn the handwheel slowly in your
direction before sewing and make sure that the
needle is not contacting the straight stitch foot and
straight stitch needle plate.
i
Attach the straight stitch foot.
mark
a
b
a b