Electrolux 51" Stainless Steel Gas Grill Use And Care Manual page 15

15
Using the Rotisserie & Side Burners
ROTISSERIE LIGHTING
Open the lid. Push and turn the control knob for the rotis-
serie counter clockwise to the "HIGH" position. Wait 5
seconds. Then press and hold the electronic igniter
button. You'll hear a snapping sound. If the burner does
not light in 4 seconds, turn the control knob to OFF and
wait 5 minutes before trying again. Once lit, turn the
control knob to the desired setting. (See Fig. 18)
MATCH LIGHTING
If by chance the electronic igniter does not light the
burner, the burner may be lit with a match. Attach the
match to the match extender, located inside the right
cart door.
Keep your face as far away from the grill surface as possi-
ble and hold a match, attached to the match extender, to
the burner , then push and turn the control knob counter
clockwise to the "HIGH" position. (See Fig. 19)
NOTE: After the first use the stainless steel around
the burner will darken. This is a normal reaction of
premium stainless steel to heat and is not a defect.
The infrared panel will also darken after initial use.
This is also a normal occurrence.
!
SIDE BURNER LIGHTING
Push and turn the control knob to the "HIGH" position
and immediately press and hold the electronic igniter
button. You'll hear a snapping sound. It may be neces-
sary to hold the electronic starter button for about 4
seconds. If the burner does not light in 4 seconds, turn
the knob to the "OFF" position and wait 5 minutes
before trying again. Repeat above steps to light
remaining burners. (See Fig. 20)
MATCH LIGHTING
If by chance the electronic igniter does not light the
burner, the burner may be lit with a match. Attach the
match to the match extender, located inside the right
cart door.
Keep your face as far away from the grill surface as
possible and hold a match, attached to the match
extender, near the burner ports , then push and turn the
control knob counter clockwise to the "HIGH" position.
NOTE: Do not operate the main
burners and infrared back burner
at the same time. This can cause
warping of the roll top grill hood.
Fig. 18
Fig. 19
Fig. 20