Rgb In (Only Rgb Input); Dvi-D In; Hdmi In; Rgb In - Panasonic PT-DW530E Operating Instructions Manual

DISPLAY OPTION menu

RGB IN

(Only RGB input)
Change this setting to change the input impedance of
the synchronous signal input.
1 ) Press ▲▼ to select [RGB IN].
2 ) Press <ENTER> button.
The [ RGB IN] screen will be displayed.
z
3 ) Press ▲▼ to select [RGB1 SYNC
TERMINAL] or [RGB2 SYNC
TERMINAL].
4 ) Press ◄► to switch.
The setting will change as follows each time
z
◄► is pressed.
LOW
LOW Input impedance is set to [LOW].
HIGH Input impedance is set to [HIGH].

DVI-D IN

Change this setting if video does not display normally
when the projector and an external device are
connected via DVI.
1 ) Press ▲▼ to select [DVI-D IN].
2 ) Press <ENTER> button.
DVI-D IN] screen will be displayed.
The [
z
3 ) Press ▲▼ to select [DVI EDID].
4 ) Press ◄► to switch [DVI EDID].
The setting will change as follows each time
z
◄► is pressed.
EDID3
Switch between fine settings for a
EDID3
moving image and for a still image.
Mainly select this when an external
device (DVD player, etc.) for
EDID1 outputting video signals of a moving
image system is connected to DVI-D
IN.
Mainly use this when an external
device (PC, etc.) for outputting video
EDID2 : PC
signals of a still image system is
connected to DVI-D IN.
5 ) Press ▲▼ to select [DVI SIGNAL
LEVEL].
58
- ENGLISH
HIGH
EDID1 EDID2 : PC
6 ) Press ◄► to switch [DVI SIGNAL
LEVEL].
The setting will change as follows each time
z
◄► is pressed.
0-255 : PC
Select this when, for example,
an external device (PC, etc.) is
0-255 : PC
connected via the DVI terminal
output.
Select this when, for example, an
external device (DVD player, etc.)
16-235
is connected via the HDMI terminal
output using a conversion cable.
Note
The optimal setting differs depending on the output
z
setting of the connected external device. Refer to the
instruction manual of the external device.
If the setting is changed, the data for plug and play
z
changes. For the plug and play compatible resolutions,
refer to "List of compatible signals" (

HDMI IN

Change this setting if video does not display normally
when the projector and an external device are
connected via HDMI.
1 ) Press ▲▼ to select [HDMI IN].
2 ) Press <ENTER> button.
The [ HDMI IN] screen will be displayed.
z
3 ) Press ◄► to switch [HDMI SIGNAL
LEVEL].
The setting will change as follows each time
z
◄► is pressed.
0-1023
Select this when, for example, a DVI
terminal output of an external device
0-1023
(PC etc.) is connected to HDMI IN
using a conversion cable, etc.
Select this when, for example,
an HDMI terminal output of an
64-940
external device (DVD player, etc.) is
connected to HDMI IN.
Note
The optimal setting differs depending on the output
z
setting of the connected external device. Refer to the
instruction manual for the external device.
The displayed HDMI signal level is the value when the
z
input is 30 bit.
16-235
Æ page 88).
64-940