Removal - Recycler/Rear Bagger Chassis; Alternate Method; Disassembly - Toro 20330 - Low Wheel Walk Power Mower Service Manual

THREE SPEED TRANSMISSION

Removal - Recycler/Rear Bagger Chassis

To remove the transmission from the chassis, raise the
rear and support it with blocks.
1. Remove both rear wheels and wheel covers.
2. Remove the rocking key clutches (see "Wheel Pinion
Clutch" on page 5-3).
3. Slide the pivot arm and spring arm off the axles.
4. Remove the belt cover. Loosen the belt guide and
slip the belt off the pulley. Disconnect shift and clutch
cables.
5. Slide the transmission to the right to slip the short
end of the axle out of the chassis.

Alternate Method

1. Pivot both spring arms until they point straight.
2. Remove belt cover and belt.
3. Disconnect shift and clutch cables.
4. Remove 4 self-tapping screws securing end caps to
housing (Fig. 120).
4-6
Fig 120 3428-0121

Disassembly

Inspection of this transmission can be accomplished
without removing the pivot arm assembly from the output
shaft. Only if components on the output shaft require
replacement will pivot arm removal be necessary.
1. Remove the six fl anged head self-tapping screws
securing the transmission cover to the transmission
case. Remove the cover (Fig. 121).
2. Before disassembling further, check for proper
operation of the input system, the gear reduction
system and gear selection system. For more
information on this, refer to "OPERATION" on page
4-3.
Fig 121 3428-0120
WPM Drive Systems Manual