Programming channels into the
TV's channel memory
When you press
TV control panel, your TV will stop only on the
channels you programmed into the TV's channel
memory.
Follow the steps below to program channels into
the TV's channel memory.
Programming channels automatically
Your TV can automatically detect all active
channels in your area and store them in its
memory. After the channels are programmed
automatically, you can manually add or skip
individual channels in the channel memory.
Note:
You must configure the ANT/CABLE input
•
source before programming channels
(
Page 28).
The automatic channel programming
•
process will erase channels that were
previously programmed into the TV's
memory.
To tune the TV to a channel not
•
programmed in the channel memory, you
must use the Channel Number buttons on
the remote control.
Programming channels when the ANT/
•
CABLE input is configured for Cable will
take substantially longer than when the
antenna input is configured for Antenna.
This is normal; however, once channel
programming is finished, you should not
have to repeat the programming process
again unless your Cable TV service lineup
changes significantly.
To program channels automatically:
1
Configure the ANT/CABLE In input if you
have not already done so (
2
From the Setup menu, press
select Installation and then press
3
Press
press
and then press
4
A screen will appear warning that previous
programs and settings will be deleted.
Downloaded from
www.Manualslib.com
Chapter 5: Setting up your TV
or
on the remote control or
Page 28).
or
or
to highlight Terrestrial, and
or
to select Channel Program
.
manuals search engine
5
Press
The TV will automatically cycle through all
the channels, and store all active channels in
the channel memory. When Auto Tuning is
finished, press
programmed channels.
Programming channels manually
After automatically programming channels into
the channel memory, you can manually
programming individual channels.
To skip channels in the channel memory
To prevent certain channels from being viewed,
channel positions can be skipped.
1
From the Setup menu, press
select Installation and then press
2
Press
press
and then press
appear.
3
Press
skipped and then press
the box. To remove the tick, press
4
To save the setting, press
Note: Skipped channels cannot be selected
with
or
accessed using the number keys on the
remote control.
to
.
to start channel programming.
or
to view the
or
to highlight Terrestrial, and
or
or
to select Channel Options
. The list of channels will
or
to
select a channel position to be
. A tick will appear in
.
; however, they can still be
to
.
again.
29