Windows Nt Driver Installation; Overview; Installing The Driver - HP LC2000r - NetServer - 128 MB RAM Manual

Fibre channel host bus adapter

Hide thumbs Also See for LC2000r - NetServer - 128 MB RAM:

Table of Contents

Windows NT Driver Installation

NOTE

Check this worldwide web address to ensure that you have the latest

version of the Windows NT driver:

http://netserver.hp.com/netserver/

If it is a newer version than the one on the supplied HP Navigator CD,

download it and use it instead of the earlier driver.

Before installing the Fibre Channel Adapter driver, the Windows NT system

should be up and running.

The HP Navigator CD contains the fibre channel HBA drivers. You need to

create a driver diskette before driver installation. Follow these procedures to

create driver diskette:

• Insert the HP Navigator CD into the HP Netserver CD-ROM, and boot

the Netserver with the CD.

• On the main menu, select Netserver utilities, then select diskette

library.

• Select the "HP D8602B Fibre Channel HBA Winnt 4.0 support disk".

• Insert a diskette into the floppy disk drive.

• Follow instructions on the screen to create driver diskette.

To install the Windows NT driver, perform the following steps:

1. Start Windows NT and log into an account with administrative privileges.

2. Insert the "HP D8602B Fibre Channel HBA Winnt 4.0 Support Disk" into

the flexible diskette drive.

3. From the Start bar, select Settings.

Table of Contents