HP D7171A - NetServer - LPr Manual page 2

Client LAN
Intra-cluster
(Heartbeat) LAN
Power source
System software:
Navigator version
Operating System
SPU
Model
Clock speed
No. of CPUs
BIOS version
CPU cache
RAM
No. of power supplies
Local storage
I/O slots
Default Boot Order
M/S Certified
Configuration
Storage
Local
Controller
Driver
Cabinets (Physical drive
location)
Disk drives
SCSI bus
SCSI Ids
Shared
HP Rack
Storage/12FC
Any NIC that is HP and Microsoft approved. See
For a SPOFless cluster, two D5013B NICs configured with AFT is
recommended.
Embedded NIC with crossover cable, or, configure as a VLAN through an
Ethernet switch. See Intra-cluster LAN
Direct from power mains, power conditioner or uninterruptible power
supply (UPS) using any power conditioner or UPS. Redundant power
distribution units (PDU's) are strongly recommended.
L.18.03 or later
Microsoft Windows 2000 Advanced Server
HP NetServer LT 6000r
550, 700 MHz
2 - 6
4.06.26 PW or later
Any size
256 MB minimum. Must be HP.
3 standard, 3 required for redundancy
See Local Storage below.
Added cards may be installed in any appropriate slot, keeping in mind the
server's default boot order as listed below:
IDE CD-ROM, FDD, Embedded A, Embedded B, PCI-6, PCI-5, PCI-4,
PCI-3, PCI-2, PCI-1
P2 - Client LAN (D5013B)
P4 – Local storage (NetRAID-1Si)
P6 - Shared Storage FC HBA
Booted from embedded DAC
May use embedded SCSI, embedded DAC, NetRAID-3Si or NetRAID-1Si.
For SPOFless, recommend embedded DAC with drives in RAID-1 mirror,
or another fault tolerant RAID level.
For embedded SCSI, use sym_hi.sys from Windows 2000 Adv. Server CD
or later.
For embedded DAC or NetRAID-xSi, use mraid35x.sys version 2.62
(Navigator L.18.04.5 or later)
SPU internal drive bays or HP external drive cabinet (e.g., HP Rack
Storage/12), any number.
Must be HP (hot swap or fixed)
Any HP cables that meet SCSI specifications and any SCSI bus speed.
Any
Required
2
Client LAN below.
below.