HP D7171A - NetServer - LPr Manual page 13

Chapter 2
1. Refer to Figure 2-3 below. To unlock the drive, push the locking latch in
and then pull the ejector handle toward you.
2. Gently pull the drive out about an inch to disengage the power connection.
3. Use your hand to support the bottom of the drive. Slowly pull the drive
straight out. Do not allow the drive to fall.
4. Place the drive in an electrostatic protected container. Do not stack drives.
Figure 2-3. Removing Hard Disk Drives From the NetServer
Removing LH 3 Covers and Components
9