HP D7171A - NetServer - LPr Manual page 11

Pci card installation and replacement and hot-plug operations

Hide thumbs Also See for D7171A - NetServer - LPr:

Chapter 6 Addendum

10. Consider the boot priority before any installing any accessory board.

If installing a SCSI controller board, the controller's priority (BIOS search order for a boot drive) is set by the

board's slot location. For details, refer to the section "Boot Priority" earlier in this chapter.

11. Identify the desired slot, before installing the accessory board. See Figure 6-5.

PCI Hot-Swap

Slots

12. If installing a new board into an unused slot, remove its slot cover on the NetServer's rear panel after

selecting the slot.

CAUTION

Do not bend the PCI board to install it into the slot. If full-length PCI boards have a handle on

the end of the board that prevents its installation, remove the handle before installing the board.

13. If the PCI board is a full-length board with a handle attached to it, remove the handle before installing the

board into the slot.

1 0

Amber LED

Green LED

Figure 6-5. I/O Slot Layout

HP NetServer LXr 8000 Installation Guide

Shared PCI/ISA

Slot

PCI (Non-Hot Swap) Slots

Table of Contents