HP D7171A - NetServer - LPr Installation Manual page 28

Chapter 3
8. Adjust the NetServer's position on the slide members to line up the
mounting holes on each side (3 each) of the chassis with the screw holes
in the slide members.
Figure 3-13. Removing the Mounting Handles
9. Insert the flathead screws into the slides' holes at the rear and the
panheads screws in the other four places to secure the chassis to the slides.
10. Use a T-15 Torx driver to remove the screws holding the handles to the
NetServer. See Figure 3-13.
11. Take the handles off the NetServer and store the handles and screws in a
convenient place. See Figure 3-13.
24
Rack-Mounting the HP NetServer