Power-Up Procedure - HP D7171A - NetServer - LPr Installation Manual

Chapter 2
d. Let go of the release latches. Now grasp the ejector handles and push
the satellite chassis the rest of the way onto the base. Be careful to
keep the ejector handles in the "down" position.
e. When the satellite chassis slides as far forward as it can go, push the
ejector handles up.
f. Replace the retention bracket as shown in Figure 2-6.
g. At the front, relatch the power supplies.

Power-Up Procedure

1. Install the AC power cord (if it was removed).
2. Install the system cables (if they had been removed).
3. Turn the power interlock switch at the rear of the HP NetServer counter
clockwise to the locked position. When the switch is locked, the slot in the
middle of the switch is vertical (Figure 2-15). The system will now power
up. Ensure the indicator lights come up correctly. See "Power Supply
Indicators" in the HP NetServer LXr Pro8 User Guide.
NOTE The interlock switch locks the satellite chassis in place. As a
safety precaution, the server cannot power up unless this
switch is locked.
22
Installing Memory in the 4 GB Memory Board