Install The Netserver In The Rack - HP D7171A - NetServer - LPr Manual

Chapter 3

Install the NetServer in the Rack

Refer to the documentation listed below to install the slides in the rack and to
install the NetServer into the rack:
To install into an HP rack: Refer to the NetServer's user guide or
installation guide. For cabling instructions, refer to the documentation that
came with the rack and either the Rack Cabling Reference for your HP
NetServer.
To install into a Compaq Rack: Refer to the HP NetServer LH 3r, LH 4r,
LH 3000r, and LH 6000r Installation Guide for Compaq
Racks. For cabling instructions, refer to the documentation that came with
the rack and either the Rack Cabling Reference for your HP NetServer.
Refer to this rack documentation for detailed instructions as you do the following:
1. Extend the anti-tip foot or ensure that the anti-tip feature is installed. Lower
the leveler feet.
WARNING To prevent the rack enclosure from tipping over,
Failure to take these precautions could result in serious injury
and equipment damage.
2. If there is a door on the rack, remove it.
24
Conversion: Install Components, Cover, and Front Bezel
Extend the anti-tip foot or verify that the anti-tip feature is
installed.
Verify that the leveler feet are lowered.
DO NOT extend more than one piece of equipment at a
time out from the front of the rack.
®
4000/7000