Step 2: Mount The Drive In The System; Mount The Drive In Shelf 5 Or 6; Mount The Drive In Shelf 3 Or 4 - HP D6030A - NetServer - E50 Installation Manual

Chapter 3

Step 2: Mount the Drive in the System

To prepare to install the drive:
Turn off your system and the display.
Disconnect the power cords.
Detach any external cables.
Remove the cover from the HP NetServer.
Remove any hardware necessary to reach the cables or insert the drive.
Consult Information Assistant on the HP NetServer Navigator CD-ROM
for your system for specific instructions for removing components.
If you are mounting the drive in shelf 5 or 6, continue with "Mount the Drive in
Shelf 5 or 6" If you are mounting the drive in shelf 3 or 4, continue with "Mount
the Drive in Shelf 3 or 4."

Mount the Drive in Shelf 5 or 6

Remove the rear-cooling fan. Confirm that the fan is operational. Replace
it if necessary.
Align the four screw holes of the rear shelf with the four screw holes of
the drive.
Loosely install all of the screws (provided with the drive), then tighten the
screws to no more than eight inch-pounds (0.9 Newton meters).
Carefully insert the fan wire fully into the drive bay.
Replace the rear cooling fan.
Continue with Step 3.

Mount the Drive in Shelf 3 or 4

Remove the drive mounting tray from the system. (See Figure 3-2.)
Figure 3-2. E 45 Hard Disk Drive Mounting Tray
Mount the Drive in the NetServer E 45 or E 50
19