HP D6030A - NetServer - E50 User Manual page 51

Chapter 5
Code Description
0180h The pattern written
at address
XXXXXXXXh was
qqqqh The pattern
read back from that
address was pppph.
0181h No Active External
Cache Memory.
0182h DiagTools Error
0183h No detected extended
memory. In the basic
test this is a
DiagTools Error.
If this result comes
from an advanced
test, it is a user error.
0184h Data Bus Test failed.
0190h Test failed at address
xxxxxxxxh.
Recommended Action
4. Check the positions of DIMMs to see that positioning matches that on the
technical reference label or card.
5. Examine the support ticket and check for failures.
6. Bring the system down to its minimum memory configuration and rerun the
test.
7. Build up the system by halves until the failure is located.
8. Change the memory board.
9. Change the system board.
10. Change the board where the DIMMs are located.
1. Visually inspect the memory board to ensure proper seating.
2. Check to see all DIMMs are the correct HP part number.
3. Visually inspect DIMM units to ensure they are properly seated.
4. Check the positions of DIMMs to see that positioning matches that on the
technical reference label or card.
5. Examine the support ticket and check for failures.
6. Bring the system down to its minimum memory configuration and rerun the
test.
7. Build up the system by halves until the failure is located.
Enable external cache memory through the BIOS Setup utility first.
Download a new version of DiagTools from the HP web site and run it. If you
get the same error, call the HP Customer Care Center.
If a basic test error, contact you HP Response center to get the latest copy of
DiagTools.
Parameter out of range. Reenter and rerun the test.
1. Visually inspect the memory board to ensure proper seating.
2. Check to see all DIMMs are the correct HP part number.
3. Visually inspect DIMM units to ensure they are properly seated.
4. Check the positions of DIMMs to see that positioning matches that on the
technical reference label or card.
5. Examine the support ticket and check for failures.
6. Bring the system down to its minimum memory configuration and rerun the
test.
7. Build up the system by halves until the failure is located.
8. Change the memory board.
9. Change the system board.
10. Change the board where the DIMMs are located.
1. Visually inspect the memory board to ensure proper seating.
2. Check to see all DIMMs are the correct HP part number.
3. Visually inspect DIMM units to ensure they are properly seated.
4. Check the positions of DIMMs to see that positioning matches that on the
technical reference label or card.
Error Message Reference
47