Restore Defaults - HP P2000 Reference Manual

restore defaults

Description For use by or with direction from a service technician.
Restores the default configuration to the controllers. For details about which settings are restored see
Settings changed by restore defaults
when the command is issued, the system's redundancy mode will be set to Single Controller
mode.
When the command informs you that the configuration has been restored, you must restart the
controllers for the changes to take effect. After restarting the controllers, hosts might not be able to
access volumes until you re-map them.
CAUTION:
reconfiguration to restore host access to volumes.
Syntax
restore defaults
[noprompt]
[prompt yes|no]
Parameters noprompt
Optional in console format; required for XML API format. Suppresses the confirmation prompt, which
requires a yes or no response. Specifying this parameter allows the command to proceed without
user interaction.
prompt yes|no
Optional. Specifies an automatic response to the confirmation prompt:
• yes: Allow the command to proceed.
• no: Cancel the command.
If this parameter is omitted, you must manually reply to the prompt.
Example Restore the controllers' default configuration:
# restore defaults
WARNING: The configuration of the array controller will be erased. Default
parameters will take effect at the next controller reset. Logical devices may
not be accessible until mappings are reconfigured. Are you sure? yes
Success: Command completed successfully. - Device default configuration was
restored.
See also • restart
on page 435. If the system contains only one controller module
This command changes how the system operates and might require some
HP P2000 G3 MSA System CLI Reference Guide 115