Brother MFC-7240 Basic User's Manual page 88

Error Message
Init Unable XX
(XX = Error Code)
Jam Inside
Jam Rear
Jam Tray
Manual Feed
No Paper
No Response/Busy
No Toner
80
Cause
The machine has a mechanical
problem.
The paper is jammed inside the
machine.
The paper is jammed in the back
of the machine.
The paper is jammed in the paper
tray of the machine.
Manual was selected as the
paper source when there was no
paper in the manual feed slot.
The machine is out of paper or
paper is not correctly loaded in
the paper tray.
The number you dialled does not
answer or is busy.
The toner cartridge is not installed
correctly.
Action
 (For FAX-2840 and MFC-7240)
Received fax messages still in memory
will be lost when the machine is turned
off. See Transferring your faxes or Fax
Journal report uu page 83 before
disconnecting the machine so you will
not lose any important messages. Then,
turn the power switch off, wait a few
seconds, and then turn it on again.
Leave the machine for 15 minutes with
the power on.
(For FAX-2950 and MFC-7290) 
Turn the power switch off, wait a few
seconds, and then turn it on again.
Leave the machine for 15 minutes with
the power on.
 If the problem continues, call Brother
Customer Service or your local Brother
dealer.
(See Paper is jammed inside the machine
uu page 88.)
(See Paper is jammed at the back of the
machine uu page 85.)
(See Paper is jammed in the standard paper
tray uu page 84.)
Place a sheet of paper in the manual feed
slot. (See Loading paper in the manual feed
slot uu page 12.)
Do one of the following:
 Refill the paper in the paper tray and
press Start.
 Remove the paper and load it again.
Then press Start.
 If the problem is not resolved, the paper
pick-up roller may need to be cleaned.
Clean the paper pick-up roller. (See
Cleaning the paper pick-up rollers
uu page 74.)
Verify the number and try again.
Pull out the drum unit. Take out the toner
cartridge and then put it back into the drum
unit.
