Remote Control (Optional Accessory) Setup; Remote Controlld Setup; Remote Controlld Delete; Dual Zone Control Setup - Kenwood KMR-700U Instruction Manual

Remote control (Optional accessory) setup
Remote controllD setup
When connecting the remote control KCA-RCl 07MR
(Optional accessory) to this unit, you should register
the ID for KCA-RCl 07MR.
1
Enter Remote control setup mode
Press the [2Z0NE] button for at least 1 second.
2
Select the Remote controllD setup item
Turn the [VOL] knob to select "Remote 10
Set'~
and then press the [ENTER] button.
Remote control 10 list is displayed. "Yes" indicates
that this 10 is already registered. "No" indicates that
this 10 is available.
3
Enable Remote control 10 registration
Press the [ENTER] button.
"Registing..:' is displayed.
4
Register Remote controllD
For KCA-RCl 07MR, press the [ENTER], [SRC], or
[OISP] button.
,Burtonwij;;;
J\eirt9~e
contJo{1D
~
..
[ENTER] 101 is registered.
[SRCj 102 is registered.
[OISP] 103 is registered.
"10# Setup Completed" is displayed.
5
End Remote control setup mode
Press the [2Z0NE] button.
Cancelling Remote control ID setup
Press the [2Z0NE] button for at least 1 second.
e
• When removing KCA-RCl 07MR, delete the registered
remote controllD, as described in <Remote controllD
delete> (page 20)
20 I
KMR-700U
Remote controllD delete
Delete the ID registered for the remote control KCA-
RCl 07MR (optional accessory).
1
Enter Remote control setup mode
Press the [2Z0NE] button for at least 1 second.
2
Select the Remote controllD delete item
Turn the [VOL] knob to select "Remote 10
Oelete'~
and then press the [ENTER] button.
List of the IDs registered for remote controls is
displayed.
3
Select the remote controllD to be deleted
Turn the [VOL] knob.
4
Delete the Remote controllD
Press the [ENTER] button.
"Remote 10# Delete?" is displayed
5
Turn the [VOL] knob to select
"YES'~
and then
press the [ENTER] button.
"10# Delete Completed" is displayed.
6
End Remote control setup mode
Press the [2Z0NE] button.
Cancelling Remote control ID delete
Press the [2Z0NE] button for at least 1 second.
Dual zone control setup
When the dual zone function is set to ON, select the
channel, either front or rear, to be controlled by the
remote control KCA-RC107MR (optional accessory) .
1
Enter Remote control setup mode
Press the [2Z0NE] button for at least 1 second.
2
Select the Dual zone control setup item
Turn the [VOL] knob to select "Remote Zone
Select'~
and then press the [ENTER] button.
Current settings are displayed for the registered
remote control 105.
3
Select the target remote controllD
Press the
[.A.]
or
[V]
button.
4
Select the target channel
Press the [
«]
or [
»]
button.
~~1'~ £_Ied1hannel~uring;iI~it_~~r:;.;!~
"Front" Front channel is controlled.
"Rear" Rear channel is controlled.
5
End Remote control setup mode
Press the [2Z0NE] button.