Sony MDR-NC500D Operating Instructions Manual page 23

SONY:
MDR-NC500D
English
3
Set the POWER switch to "ON."
The POWER indicator lights up in blue, and a short
beep sounds from the unit.
2
Connect the headphones to the AV
equipment.
See the Operating Instructions for details.
MONITOR
button
1m,
~~~
POWER
indicator
AI NC MODE
button
'~'Tip
You can also set the noise canceling mode manually (manual
noise canceling). See the Operating Instructions for details.
Sounds come from the headphones to inform you that
the unit has started analyzing ambient sound
components (approx. 3 seconds). During analysis,
sound reproduction from the unit is stopped and the
POWER indicator lights in pink. When analysis is
completed, the most effective noise canceling mode
is set automatically, and sound reproduction from the
headphones starts.
Hearing environmental sound for safety
If the MONITOR button is pressed and held while
the POWER switch is set to ON, playback silences
then you can hear the surrounding environment.
Monitor microphone
7
Set the POWER switch to "OFF"
after use.
5
Start playing on the AV equipment
connected to the headphones.
Note
Playback is not available when there is no power.
6
Press the AI NC MODE button.
:@-
Charge
indicator
To DC IN 6V
jack
AC power adaptor
(supplied)
To an AC outlet
Headphones
Charging is completed after about three hours, and
the charge indicator goes out. Disconnect the AC
power adaptor after the charging has finished.
'~'Tip
You can use the supplied connecting cord with hattery case.
See the Operating Instructions for details.
Startup guide
1
Charge the headphones.
Connect the supplied AC power adaptor to the DC IN
6V jack on the headphones and an AC outlet. The
charge indicator lights up in orange and charging
starts.
4
Put on the headphones.
After confirming the cord on the left and the POWER
switch on the right, put on the headphones.
II11I1111111111111111111111111111111111111111111111111I
*
3 2 7 5 9 9 7 1 1
*
(1)
©2008 Sony Corporation
Printed in Malaysia
3-275-997 -11 (1 )