Step 2—Installing the PCIe NIC hardware
1.
If your computer requires a low-profile card, replace the full-height bracket on the card with the
supplied low-profile bracket.
2.
To install the NIC in the selected PCIe slot:
a.
b.
Figure 2
3.
For computers that support DASH, attach the USB cable provided to the USB connector on the
NIC (3), and then to the DASH-enabled USB dual (10–pin) header on the system board (4).
NOTE:
For information to determine DASH compatibility, see
Figure 3
4
Broadcom NetXtreme Gigabit Ethernet Plus Network Interface Card installation
Verify the keyed components of the card align with the socket (1), and then press the card
securely into the socket.
Close the PCI levers (2).
Installing the NIC
To locate the DASH-enabled USB, see the service label inside the side access panel.
Connecting the USB cable for DASH-enabled computers
on page
1.
ENWW