HP Xw4400 - Workstation - 2 GB RAM Installation Manual page 6

HP xw8000 and xw9000 Workstation series
1. Install the DX115 unit in the optical drive bay using the quick release system
2. Install one M3 x 5mm screw (black) per DX115 unit for shipping support as shown.
CAUTION:
system.
Step 3—Installing a hard disk in the DX115 carrier
CAUTION:
Other procedures may result in system hangs, data loss or even drive damage. (The component
supplier's user guide describes a procedure for inserting or removing the carrier (with drive) while the
workstation is booted and then powering the drive via the enclosure's power switch. Microsoft Windows
XP and Vista do not support this action.)
NOTE: It is not necessary to remove the DX115 case from the workstation for this step.
Install your hard drive in the DX115 carrier. For detailed instructions, refer to either:
●
The CRU Dataport DX115® User's Guide for SATA or SAS removable drive enclosures
● The CRU Dataport website at
dx115.html
6 CRU Dataport DX115 kit installation
Failure to install the shipping screw may result in damage to the removable hard drive
Insert or remove the carrier (with a disk drive) only when the workstation is shut down.
http://www.cru-dataport.com/htmldocs/products/dataexpress/
ENWW