Yamaha mLAN Installation Manual page 18

When connecting the i88X
3
On mLAN Auto Connector, set up the word-
clock and specify the number of audio chan-
nels (see below).
q
w
t
u
i
o
q Nickname
This field indicates the nickname of the connected i88X. To
change the nickname, refer to "Node Information" in the
mLAN Graphic Patchbay Manual.
w Model Name
This parameter enables you to select an mLAN device to
which you wish to make an mLAN connection in a multiple
mLAN device network.
e [Update] button
Clicking this button updates the information on the mLAN
devices connected to the mLAN network. Use this button
when you add an mLAN device to the network while mLAN
Auto Connector is running.
r [Identify] button
Clicking this button causes the i88X ACTIVE indicator to
flash for a few seconds.
t Sample Rate
This parameter enables you to specify the sampling fre-
quency (wordclock frequency).
y Wordclock Master radio buttons
These buttons enable you to specify the computer or i88X as
the wordclock master.
u PC → i88X
This parameter enables you to specify the number of chan-
nels of audio data routed from the computer's audio output
(mLAN driver's audio output) into the i88X. Signals input in
the i88X are output from the i88X's OUTPUT 1-8 jacks (ana-
log), DIGITAL STEREO COAXIAL or OPTICAL OUT jack
(digital), or ADAT OUT jack (ADAT).
!0 !1
i PC ← i88X
This parameter enables you to specify the number of chan-
nels for audio data that is input at the i88X's INPUT 1-8
jacks (analog), DIGITAL STEREO COAXIAL or OPTICAL
IN jack (digital), or ADAT IN jack (ADAT) and output to the
computer.
e
o [Connect] button
r
Click this button to connect the i88X to the computer via
mLAN. When the connection is completed, the mLAN Auto
y
Connector window will close automatically.
!0 [Cancel] button
Click this button to cancel the settings and close mLAN Auto
Connector.
!1 [Setup] button
Click this button to open the i88X Control Panel window,
which enables you to set the wordclock transition speed.
4
Click [Connect]. If the connections have
been made properly, the mLAN Auto Con-
nector completes operation and the mLAN
data communication starts.
NOTE
• If for some reason connection fails, right- click the mLAN Driver
icon in the task bar to restart the mLAN Auto Connector and click
[Connect] again. You need not restart your computer.
mLAN Driver/mLAN Tools Installation Guide
18