Advertisement
WARNINGS
• Use a heavy metal vent.
• Do not use plastic or thin foil duct.
• Failure to follow these instructions
can
result in death or fire.
• Clean old ducts before
installing
this dryer
Vent end will face to the outside home and
improper taping and unstable installation of vent
will cause undesirable drying performance,
In addition
to the following
warnings,
please refer
to manual section on Exhaust
Requirements
and
Maintenance.
iMPORTANT:
To reduce the risk of
fire, combustion,
and gas accumulation,
the dryer
must be vented to the outdoors.
Please follow the
instructions
(and all others in this manual
very
carefully.
• Do not use Plastic or thin foil duct.
• Use 4" (10.2 cm) diameter
rigid or Semi-rigid
metal duct (note:
venting materials
are not
supplied
with the dryer, and you should obtain the
venting materials
necessary
for proper installation)
• Position
the Dryer such that the exhaust
duct run is
as short as possible.
• Clean old ducts beJbre installing
this dryer
• The male end of each section of exhaust duct must
point away from the dryer
• Use as few elbow joints as possible.
• Use duct tape on all duct joints
• Insulate ductwork
that runs through
unheated
areas in order to reduce condensation
and lint
build-up
on pipe walls.
• PLEASE
BE AWARE
THAT FAILURE
TO
EXHAUST
THE DRYER
CORRECTLY
WILL
VOID THE DRYER'S
WARRANTY.
•
ALTERNATE
EXHAUST
DIRECTIONS
]. Remove screw and exhaust duct.
2- |. Detach and remove the knockout that
matches the desired venting direction
(Right side not available on Gas Dryers)
0), @), _3)the order of work.
PORTION
"A"
I
Knockout
\
2-2.
Q
Reconnect the duct to the blower
housing and attach the duct to the
base.(Duct
is a SVC part)
f
\
3-1.
Pre-assembte
4" elbow with 4" duct.
Wrap duct tape around joint.
DUCT
TAPE
3-2°
Insert elbow duct assembly first through the
side opening and connect the elbow to the
internal duct.
9
Advertisement
