Advertisement
2
Wear
If you normally wear glasses or contact lenses, wear them as usual during use (with the exception of reading
glasses). Note that watching with bifocals may be less than optimal.
On one side after another, hold the band release
button down and pull out the headband.
Lower the bottom headband strap to the base of your
head.
3
Set Up
Press the / button to select a
language, and then press the MENU or
button.
Slide each lens span
adjuster until you can see
both screens clearly.
After adjustment, press the MENU button or button.
Tips
If you cannot see the screen clearly after lens span
If adjustment is difficult, try sliding both adjusters to the
Confirm that all three "I" marks and the horizontal line
intersect, and then press the MENU or button.
All three "I" marks and the
It is acceptable if the "I" marks and the horizontal line
horizontal line intersect.
intersect in a position other than the center of the
screen.
Note
If even one of the "I" marks and the horizontal line do
More than one of the "I" marks and
the horizontal line do not intersect.
After reading the information, press the MENU or
button.
Wearing the unit will prevent you from seeing outside the display.
to review steps 2 – 4 (Wear, Set up, and Enjoy), so that you know the sequence of procedure.
For a Comfortable Fit
Support the unit with your forehead
and at two positions on the back of
your head.
Do not rest on your nose.
Adjust the unit so that the screens
are in front of your eyes.
Eye
Screen
Pull out the headband.
Put the head mounted unit on your
head.
Follow the instructions displayed on
the screen for operations.
Select a display language (first time
only).
Adjust the lens span.
adjustment, start over from "2 Wear."
center position before adjustment.
Check display alignment.
not intersect, stop using the system. For details, see the
"Reference Guide."
Follow the instructions displayed.
Adjust the position on your head.
Carefully adjust the unit left, right, up, and down to find the
best position for viewing the center of the screens.
Notes
If the unit detects that the forehead supporter is not against
your forehead during viewing, the screens will be deactivated.
Make sure the forehead supporter rests securely against your
forehead.
If the forehead supporter is too far back (toward your
forehead), it may be difficult to see the screens. In this case,
holding the lock lever toward the left, lift the forehead
supporter and push the supporter forward.
Tighten the headband securely.
Tip
The length of the top and bottom headband straps can be
adjusted. For details, see the "Reference Guide."
Wear the headphones.
Wear the earpiece marked R in your right ear and the one
marked L in your left ear.
To remove the head mounted unit
Remove the headphones from your ears before taking off
the head mounted unit.
Hold the band release buttons on both sides and pull the
unit forward as you lift it off.
4
Enjoy
Control playback from compatible playback
sources.
Controlling Playback from the Unit
Fast-rewind
Hold the button down
to jump to the previous
chapter.
Volume
For details on configuring menu settings and attaching accessories, see
the "Reference Guide."
Note
To resolve a lack of audio, video, or 3D playback when the system is connected to a PlayStation ® 3
(PS3™), see the instructions on the page to the right of the cover for troubleshooting.
Before you put it on, take a moment
Play
Power on/
standby
Hold the button down
to enter standby mode.
Fast-forward
Hold the button down
to jump to the next
chapter.
Pause
Notes
The system cannot be used for advanced
playback equipment control, such as menu
operations.
Control using these buttons is only possible when
the "Control for HDMI" in "General Setup" is set to
"On" (default setting).
Some playback equipment cannot be controlled
using the head mounted unit buttons.
Advertisement
