Table 5: Basic Settings Commands - D-Link DWL-6600AP Cli Command Reference

D-Link UAP CLI Command Reference
Action
View the following information about the
management interface on the AP:
• VLAN ID
• Interface name
• Static IP address (if DHCP is not used)
• Static subnet mask
• IP address
• Subnet mask
• MAC address
• DHCP status
• IPv6 status
• IPv6 auto configuration status
• Static IPv6 address
• Static IPv6 prefix length
View the firmware version.
View the serial number.
Set the password.
Set the baud rate for the serial port.
Set the system name.
Set the system location.
Set the administrator's contact information.
Set the time zone.
Enable or disable the Aeroscout feature,
which is used to perform location detection.
Enable the Bonjour protocol to allow
discovery of services offered by other
Bonjour-enabled devices on the network.
D-Link
November 7, 2011

Table 5: Basic Settings Commands

Command
get management
get system version
get system serial-number
set system password password
Example:
set system password test1234
set serial baud-rate
set system system-name name
Example:
set system system-name "AEO AP"
set system system-location location
set system system-contact contact_info
set system time-zone time zone
Example:
set system time-zone "USA (Alaska)"
set aeroscout admin-mode {up | down}
set bonjour status {up | down}
Unified Wired and Wireless Access System
Basic Settings
Page 23