Table of Contents
Advertisement
• Remote Control
You can control the SEQUENCE, MULTISCREEN/QUAD SHIFT, and the camera selection buttons from a remote con-
troller. These functions are activated by contact with the ground terminal (open collector output or normally open con-
tact).
• Connect the ALARM/REMOTE connector (pin 23) to the ground terminal as shown below. Switches 1 - 16 select the
cameras (they do not control the alarm input).
Notes:
• Any two or more switches closed at the same time will cause this unit to malfunction.
• SEQUENCE is assigned to switch 17 and MULTISCREEN/QUAD SHIFT to switch 18.
• When no operation is taking place, all switches except switch 19 must be open as shown below.
D-SUB CONNECTOR
(MALE)
Switch
19
18
17
16
15
14 13 12 11 10 9
8
7
6
Camera Selection
-25-
Switch
5
4
3
2
1
Advertisement
Table of Contents
