Hitachi CP-WX1100 Network Manual page 49

Computer
NOTE
• With using the HALF-DUPLEX method, the projector can send out
254 byte data as maximum at once.
• If it is not required to monitor the response data from an external devise and
the RESPONSE LIMIT TIME is set to OFF, the projector can receive the data
from the computer and send it out to an external devise continuously.
The OFF is selected as the default setting.
3.7.4.2 FULL-DUPLEX
This method lets the projector make two way communication, transmitting and
receiving data at the same time, without monitoring response data from an
external devise.
With using this method, the computer and an external devise will send the data
out of synchronization. If it is requited to synchronize them, set the computer to
make the synchronization.
NOTE
• In case that the computer controls to synchronize transmitting
and receiving the data, it may not be able to control an external devise well
depending on the processing status of the projector .
[1][2][3][4][5]
LAN cable
[6][7][8]
3. Management with Web browser software
[1][2][3][4][5]
Control cable
[6][7][8]
External devise
[9][0]
t
T (: bytes interval timeout) < t
49