Chapter 21
S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
sdv commit vsan
To commit an SDV configuration to a specified VSAN, use the sdv commit vsan command in
configuration mode. To remove the SDV configuration for a specified VSAN, use the no form of the
command.
Syntax Description
vsan-id
Defaults
Disabled.
Command Modes
Configuration mode.
Command History
Release
3.1(2)
Usage Guidelines
To use this command, you must enable SDV using the sdv enable command.
Examples
The following example shows how to commit an SDV configuration to a specified VSAN.
switch# config t
Enter configuration commands, one per line.
switch(config)# sdv commit vsan 2
The following example shows how to uncommit an SDV configuration from a specified VSAN.
switch# config t
Enter configuration commands, one per line.
switch(config)# no sdv commit vsan 2
Related Commands
Command
show sdv database
sdv enable
OL-18089-01, Cisco MDS NX-OS Release 4.x
sdv commit vsan vsan-id
no sdv commit vsan vsan-id
Specifies the number of the VSAN. The range is 1 to 4093.
Modification
This command was introduced.
Description
Displays the SDV database.
Enables SDV.
End with CNTL/Z.
End with CNTL/Z.
Cisco MDS 9000 Family Command Reference
sdv commit vsan
21-17