Epson Stylus Pro 7890 User Manual page 150

Epson Stylus Pro 9890/9908/7890/7908
F
Select the size of the data created by the
application from the Page Size list, and
select the roll paper width loaded in the
printer for the Roll Width or Output Paper.
Note:
Settings in applications that support banner
printing are ignored.
G
Make sure the Optimize Enlargement
check box is selected.
H
Check other settings, and then start
printing.
User's Guide
Printing Varieties
Making Settings for Mac OS X
A
When the Print screen is displayed, select
the size of the data created with the
application in Paper Size.
When using Mac OS X 10.4, or if items on
the Page Setup screen are not displayed on
the Print screen due to the application
being used in Mac OS X 10.6 or 10.5, display
the Page Setup screen and make settings.
See "Printing procedures (Mac OS X)"
on page 55
You can also perform borderless banner
printing by selecting the Paper Size as
shown below. Where XXXX is the actual
paper size, such as A4.
XXXX (Roll Paper - Banner): Prints a 0 mm
margin at the top and bottom, and a 3 mm
margin on the left and right.
XXXX (Roll Paper - Borderless Banner): The
printer driver expands the print area by
approximately 3 mm to the left and right in
regards to the paper width so that there is
no 3 mm margin on the left and right.
Therefore, you need to create data that is 3
mm wider than the paper size on the left
and right in advance. The top and bottom
margins are 0 mm.
Select Manage Custom Sizes from the
Paper Size list, and then set the paper size.
150