Epson 500DN - B Color Inkjet Printer Using Instructions page 3

4. To feed the media all the way through the printer, hold down the d button on the printer control panel. Continue
feeding media until enough emerges for you to attach it to your take-up roller, if you are using one.
Caution:
NEVER pull roll media through the printer with your hands or you may damage the
printer. ALWAYS use the d or u button to feed media. Check to make sure the media
is straight all the way through the "web" (paper path of the roll media feeding
system). Adjust the media position, if necessary.
5. Send your roll media print job as described in your RIP software documentation
or your printer documentation.
Note:
If you need to cancel a print job, first cancel any queued print jobs using the Windows
Print Monitor utility in your computer's system tray. Then press the + Cancel button
on the printer's control panel to cancel the current print job.
6. When your print job is completed, do one of the following:
To print additional jobs on the same media, simply send the other print jobs.
•
To remove the printed media, but leave the same media loaded, cut the media where it is output from the front of
•
the printer and remove the printed media.
Hold down the d button on the printer control panel to feed more media through the printer until enough
emerges for you to attach it to your take-up roller, if you are using one.
To remove the roll media from the input reel, cut off the printed media as shown above. Then hold down the
•
u button on the printer control panel until the media feeds all the way back through the printer and remove the
roll media.
Note:
The printer will not enter power-saving mode while roll media is loaded.
Roll Media Tips
For best results, always ensure the roll media loads straight into and out of the printer. To avoid reloading roll media,
•
always cut off printed media where it is output from the front of the printer. You also use less media this way.
Store unused media in a sealable plastic bag to protect it from dust and humidity.
•
ALWAYS use
the media feed
buttons
Cut media where it is
output at front of printer
3