Sony MDR-X10 Operating Instructions

Stereo Headphones
Operating Instructions
Manual de instrucciones
MDR-X10
English Stereo headphones  Soft head cushion provides long-term listening
comfort.
Features
 Multiple-folding design for optimum
 Newly developed 50 mm driver unit for wide portability.
 Newly developed, tangle-free serrated cord
response, and naturally powerful bass. OFC
voice coil allows for high input level (up to Tiny serrations in the flat cord reduce tangling
3,000 mW). caused by friction.
 Newly developed Advanced Direct Vibe
Structure
Provides an acoustically-tight seal for superior
sound isolation and deep bass. Optimized
diaphragm front chamber for more expansive
and clear mid-range sound.
 Newly developed seamless earpad
Elasticized leather covered urethane pads with
seamless ear contact area for the ultimate in
wearing comfort and superior sound isolation
for deep bass.
©2012 Sony Corporation Printed in China
4-430-815-12(1)
How to use
Tactile dot
Align small projections
with slots.
Using the Center button Specifications
Plays/pauses a track of the connected iPod Type: Closed, dynamic / Driver unit: 50 mm,
dome type (OFC Voice Coil) / Power handling
product with a single press. Skips to the next
track with a double press. Skips to the previous capacity: 3,000 mW (IEC*) / Impedance: 24 Ω at
track with a triple press. Starts the "VoiceOver*" 1 kHz / Sensitivity: 106 dB/mW / Frequency
feature with a long press (if available). response: 3 Hz – 29,000 Hz / Cord: 1.2 m
Press once to answer the call. Press again to end. (47 1 / in), Litz cord(inline remote and microphone
4
Hold down for about two seconds to reject an cord for iPod/iPhone/iPad) / Plug: Four-
incoming call. When you let go, two low beeps conductor gold plated L-shaped stereo mini plug
confirm the call was rejected. (inline remote and microphone cord for iPod/
iPhone/iPad) / Mass: Approx. 300 g (10.58 oz)
* Availability of the "VoiceOver" feature depends
without cord / Open circuit voltage level of the
on iPod and its software version.
microphone: –42 dB (0 dB = 1 V/Pa)
Note
Supplied accessories
Be careful not to unintentionally press any
Inline remote and microphone cord for iPod/
buttons when you carry your iPod with this unit
iPhone/iPad (1) / Carrying case (1)
connected.
* IEC = International Electrotechnical
Commission
Design and specifications are subject to change
without notice.
* T here is a tactile dot beside Volume +.
Volume +*
Microphone
Center button
Volume –
Inline remote and microphone cord
iPod/iPhone/iPad
Precautions
The validity of the CE marking is restricted to only
those countries where it is legally enforced,
High volume may affect your
mainly in the countries EEA (European Economic
hearing. For traffic safety, do not use
Area).
while driving or cycling.
Optional replacement earpads can be ordered
from your nearest authorized Sony retailer or
 Because the headphones are of a high density
www.sony.com.
enclosure, forcing them against your ears may
result in eardrum damage. Avoid using the
headphones where they are liable to be struck
by people or other objects, such as a ball, etc.
Pressing the headphones against your ears may
produce a diaphragm click sound. This is not a
malfunction.
 The supplied connecting cord is made
especially for the headphones. Other
connecting cords cannot be used with the
headphones.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
Before putting the headphones in the supplied
carrying case, disconnect the cord. Otherwise the
cord may break.
Compatible iPod/iPhone/iPad On copyright
®
models iPhone , iPod
iPod shuffle
You can use the unit with only the following
of Apple Inc., registered in the U.S. and other
models supporting remote control. Update your
countries. iPad
iPod, iPhone or iPad to the latest software before
"Made for iPod, " "Made for iPhone, " and "Made for
use. In the Operating Instructions, iPod, iPhone
iPad" mean that an electronic accessory has been
and iPad are collectively described as "iPod"
designed to connect specifically to iPod, iPhone,
except in special cases.
or iPad, respectively, and has been certified by
 iPod touch 4th generation
the developer to meet Apple performance
 iPod touch 3rd generation
standards. Apple is not responsible for the
 iPod touch 2nd generation
operation of this device or its compliance with
 iPod nano 6th generation
safety and regulatory standards.
 iPod nano 5th generation (video camera)
 iPod nano 4th generation (video)
 iPod classic 120GB 160GB (2009)
 iPod shuffle 4th generation
 iPod shuffle 3rd generation
 iPhone 4S
 iPhone 4
 iPhone 3GS
 iPad (3rd Generation)
 iPad 2
 iPad
® ® ®
, iPod classic , iPod nano ,
® ®
, and iPod touch are trademarks
®
is a trademark of Apple Inc.