D-Link DSN-3200-20 - Xstack 8X1GBE Iscsi San Array 15 Bays 3U Quick Installation Manual page 11

1
Insert an Ethernet crossover cable
into the management port of the
DSN-3000 series and connect the
other end to your management
system's open Ethernet port (the
one set to IP address 192.168.1.2).
Note: The management port of
the DSN-series does not support
MDI and will require a crossover
cable. Or if you wish, two standard
straightthrough cables may be used
with an intermediate switch or hub.
The management port is 100MbE.
2
Insert an Ethernet cable into Host
Network Connection #0 of the
DSN-3000 series as identified on
page 6 and the other end to a 1GbE
port of your SAN network.
3
Insert each of the three power
cables into the power supply as
shown below. Then plug the other
end of these power cables into a
reliable filtered power source such
as a UPS (Uninterruptible Power
Supply).
Proceed to Software Installation Overview for
the DSN-3000 series.
D-Link DSN-3200/3400 Installation Guide
Installing the DSN-3200
11