Editing Effect Parameters; Selecting An Effect Type - Yamaha 503 Reference Manual

Editing EFFECT Parameters

Selecting an Effect type

1
Press the [F] (TYPE) button in the EFFECT Page of the Mixing Console display.
The Effect Type Selection display is called up.
2
Use the [1 ▲▼]/[2 ▲▼] buttons to select the effect BLOCK.
Effect Block
REVERB
CHORUS
DSP1
8
DSP2–4
(CVP-505/
503/501)
DSP2–6
(CVP-509)
DSP7
(CVP-509)
DSP8–9
(CVP-509)
When the "Connection" parameter of the DSP1 (selected on step 3 of "Editing and Saving the effect" section on
NOTE
effect will be applied overall to the Style and Song. When it is set to "Insertion," the DSP1 effect will behave as same as other DSP blocks and be applied
to only the part(s) selected in step 3.
3
Use the [3 ▲▼]/[4 ▲▼] buttons to select the part to which you want to apply the
effect.
Please note that a part cannot be selected if the selected block is REVERB, CHORUS or DSP1.
4
Use the [5 ▲▼]/[6 ▲▼] buttons to select the effect CATEGORY.
72
CVP-509/505/503/501 Reference Manual
Effect-applicable Effect characteristics
parts
All parts Reproduces the warm ambience of playing in a concert hall or
jazz club.
All parts Produces a rich, "fat" sound as if several parts are being played
simultaneously. In addition, other type effects (such as reverb,
delay, etc.) can also be selected in this effect block.
STYLE PART, This effect is applied only to Style/Song parts.
SONG CHANNEL
1–16
RIGHT 1, RIGHT 2, Any unused DSP blocks are automatically assigned to the appro-
LEFT, SONG priate parts (channels) as needed. One DSP block is available only
CHANNEL 1–16, for one of the keyboard parts or Song parts.
Microphone sound* * Handled only by DSP4.
(CVP-505/503)
Microphone sound This effect is applied to the MIC input, in addition to the Vocal
Harmony effect.
STYLE PART These effects are applied only to Style parts.
2 3 4 5
page 73) is set to "System," the DSP1