Advertisement
•
Assemble the large and small spray gun clips to the
side of the tank using two #10 x 1/2" screws and #10
lock washers. See figure 8.
#10 x 1F2"
SCREW
#10 LOCK
WASHER
SPRAY GUN
CLIP (LARGE)
_SPRAY
GUN
CLIP (SMALL)
FIGURE 8
Slide a 3/8" hose clamp onto the boom connecting
hose. Place the end of the hose through the conduit
clamp (attached to the pump) and then slide a
second 3/8" hose clamp onto the hose. Leave hose
clamps loose for now. See Figure 9.
Push the hose onto the hose adapter in the end of
the "On-Off" valve. Tighten the hose clamp around
the hose and adapter. See figure 9.
Position the valve and hose clamp up against the
conduit clamp. Slide the other hose clamp against
the other side of the conduit clamp. Tighten the
clamp without collapsing the hose, See figure 9.
Slide the 1/4" hose clamp onto the spray gun hose
and then push the hose onto the hose adapter on the
1/4" tee fitting. Tighten the hose clamp around the
hose and adapter. See figure 9.
Wrap the hose around the top of tank and snap the
spray gun into the clips on the front of the tank. (The
large clip holds the spray gun handle and the small
clip holds the wand.) Refer to figure 8.
\ \\
3/8" HOSE CLAMPS
FIGURE 9
114" TEE
CONDUIT
HOSE
CLAMP
VIEWED FROM FRONT
Attach the sprayer to the tractor hitch and connect
the wiring to the tractor battery. The red wire must be
connected to the positive post on the battery or to the
"HOT" connection on a tractor switch or ammeter.
The brown wire may be grounded or connected to
the negative battery post. See figures 10 and 11.
IMPORTANT:
This sprayer should be connected to 12
volt batteries only!
PUMP SWITCH
QUICK COUPLER
RED
RED
\
BROWN
BROWN
FIGURE 10
BA'I-FER¥
&
NEVER ALLOW NEGATIVE PIN ON
PLUG TO COME IN CONTACT WITH
POSITIVE "HOT" POST ON BATTERY.
FIRE OR EXPLOSION MAY RESULT!
PLUG
J
POSITIVE
"HOT"
POST
NEGATIVE PIN
_ NEGATIVE
POST
12 VOLT TRACTOR BATFERY
FIGURE 11
6
Advertisement
