Saving Film - Canon CanoScan D1230UF User Manual

Saving Film

To save the scanned film;
1. Set the film in the film guide and place it on the scanner.
2. Push the Film Scan Button to start the CanoScan Toolbox.
3. Select [Scan and Save the Image] from theCanon Scanner Assistant and click [Next].
4. Select either [Quick and Easy Scanning](displaying scanner driver window) or [Expert
Scanning](without displaying scanner driver window).
5. If you select [Quick and Easy Scanning];
(1) Specify the setting items and click [Next].
If you select [Expert Scanning];
(1) The Plug-in Module window displays.
(2) Select [Film] from [Preferences] menu and specify [Film Size] and [Film Type] in the
[Film] menu.
(3) Adjust the previewed image and click [Scan].
6. The document is scanned. Enter the file name and specify the folder and the drive in which the
image is saved (Initially, the file name is set to Image0001 and the folder is set to [Photo] in
[CanoScan Toolbox]).
CanoScan Toolbox
When you scan the 35mm film without
displaying the driver software, the scanned area
is slightly smaller than the actual frame.
With 35mm sleeve film, up to 3 frames can be
scanned continuously. Select [Sleeve] in [Scan
Frames] and specify the scanned frames in
[Frame Selection].
When you scan 2 or 3 frames continuously,
sometimes the gap between frames may be
scanned and the vertical stripe may appear in the
image. This occurs because the width between
frames differing from the film type and setting
position causes slight disalignment of the
scanned area. In this case, place the objective
frame in the first position and scan one frame at a
time.
12