Specifying The Area To Detect Multifeed [Document Check Area Specification For Multifeed Detection] - Fujitsu 6240 - fi - Document Scanner Operator's Manual

Chapter 9 Operational Settings
Specifying the Area to Detect Multifeed
[Document check area specification for Multifeed
Detection]
The following setting is only available when you specified
[Check Overlapping (Ultrasonic)] or [Check Overlapping and
Length].
1
From the listing on the left, select [Device Setting 2]
[Document check area specification for Multifeed
Detection].
Select the [Selected range] check box in the dialog box.
2
Specify the detection range.
Range
Selected range Select the check box to specify the detection
range (colored in light blue) in the picture below.
Select the check box to enable the setting in this
dialog box. Clear the check box to disable the
setting. Clearing this check box sets both start
and end positions to "0", making the whole
document to be detected for multifeeds.
The above condition applies when the document
is set to the center of the pick roller width.
Disable Does not detect multifeeds for the selected area.
(Middle)
Enable Detects multifeeds for the selected area.
(Middle)
Start Displays the start position of the detection by the
(Middle) length from the leading edge of the document.
Range: 0 to 510 mm, in 2 mm increments,
Start<End
End Displays the end position of the detection by the
(Middle) length from the leading edge of the document.
Range: 0 to 510 mm, in 2 mm increments,
Start<End
Description
Middle
35
Range
Document
Unit: mm
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
182