Configure Wep - D-Link DIR-505 User Manual

Section 4 - Security

Configure WEP

It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the
added overhead.
1. Log into the web-based configuration by opening a web browser and entering the IP address of the router (192.168.0.1).
Click on Wireless Setup on the left side.
2. In the Security Mode section, select WEP from the drop-down
menu.
3. In WEP Key Length, select either 64Bit or 128Bit encryption from
the drop-down menu.
5. Next to WEP Key 1, enter a WEP key that you create. Make sure
you enter this key exactly on all your wireless devices. You may
enter up to four different keys either using Hex or ASCII. Hex is
recommended (letters A-F and numbers 0-9 are valid). In ASCII all
numbers and letters are valid.
6. Click Save Settings to save your settings. If you are configuring
the router with a wireless adapter, you will lose connectivity until
you enable WEP on your adapter and enter the same WEP key as
you did on the router.
D-Link DIR-505 User Manual 50