Command Line Interface - D-Link DG-102S User Manual

Command Line Interface

The DG-102S VoIP Gateway offers a line-at-a-time prompt and response scheme
to execute various configuration instructions. The interface displays a single
prompt character ggdbg> when it is ready to accept a command (ex.
ggdbg>set or ggdbg>show).
Typing a question mark after the ggdbg> prompt will display a list of helpful
user commands. Please note that all characters must be entered in lower case.
All command line examples in this chapter are in bold type.
Listed below are some of the most commonly used commands, parameter(s),
and examples of their usage.
General Setup Commands
nwdbg system reboot
Definition:
Parameter(s):
Example:
nwdbg save changes
Definition:
Parameter(s):
Example:
nwdbg factory reset
Definition:
Parameter(s):
Example:
54
This command is used to restart the device.
None.
nwdbg system reboot
This command is used to save configuration changes
into flash memory and restart the device.
None.
nwdbg save changes
This command is used to set the DG-102S back to its
default settings and then restart the device.
None.
nwdbg factory reset