Audio I/O Terminal - Canon Vb-C60 - Ptz Network Camera Start Manual

Audio I/O Terminal

You can send and receive audio via a viewer, by connecting a microphone and a speaker with
amplifier to the camera. ø3.5 monaural mini-jack connector is used.
Audio Input Terminal (LINE IN and MIC IN)
An audio input terminal is to connect a microphone to VB-C60. Two types of microphones, LINE
IN and MIC IN, are available for VB-C60 audio input. Since the available audio input terminal is
only one, you need to switch the input mode in the setting page depending on the microphone to
be used (→ dOperation Guide P.1-27). The factory default setting is Line IN.
LINE IN allows connecting with a microphone with amplifier.
MIC IN allows connecting with a dynamic microphone or a condenser microphone.
Input terminal: ø 3.5 mm monaural mini-jack
- Dynamic microphone / IN
Input impedance: 1.75kΩ ±20%
* Available microphone
Output impedance: 400Ω ~ 600Ω
- Condenser microphone / IN
Input impedance (mic bias): 2.2kΩ ±20%
Power: Plug-In power (voltage: 1.8V)
* Available microphone
Plug-in power type condenser microphone
- LINE IN
Input level: Max. 1 V p-p
* A microphone with amplifier is required.
Audio Output Terminal (LINE OUT)
An audio output terminal is to connect a speaker with amplifier to VB-C60. You can send audio
from VK-Lite Viewer to the speaker. Only the administrator can use this function.
- Output level: Max. 1V p-p
* A speaker with amplifier is required.
● Switch between LINE IN and MIC IN in the setting page according to the type of
microphone (→dOperation Guide P.1-27). Be sure to set properly, otherwise the
Note
camera or the microphone may be broken.
● The volume and tone may vary depending on the properties of the microphone.
● Use VK-Lite Viewer to send audio to the speaker. You cannot send audio from
VB-C60 Viewer (→ P.1-8).
Built-In Terminal
3-7