Advertisement
Available languages
Available languages
8
en | The Recovery Procedure
Reset
19. Choose, whether you want to load the saved configuration
F.01U.076.409 | V1 | 2007.11
Resets the system to the factory settings.
Note: Data of cameras not connected to the system,
and data of network cameras will be renamed
(<archive name>.unknown).
or reset the system to the factory settings.
To load the saved configuration:
–
Click Load.
–
Select the configuration file and then click Open. The
system loads the configuration file and starts DiBos.
The DiBos logon dialog box appears.
–
Enter the user name and the password, and then click
OK. The DiBos user interface appears.
–
If no HW dongle is plugged in DiBos, activate the
license packages in the DiBos configuration. To
perform this, click the Administration and dongle
menu, and then activate the software in the Licensing
field.
–
If a HW dongle is plugged in DiBos, if necessary, load
the dongle extension file and activate existing
software license packages in the DiBos configuration.
To load a dongle extension file, click the Administra-
tion and dongle menu, and then in the HW dongle
extension file field click Load new file.
To activate software license packages, click the
Administration and dongle menu, and then activate
the software in the Licensing field.
–
In the DiBos configuration, click the Security and
network menu. In the Transmission rate and UDP
tunneling boxes, enter all settings you wrote down
before.
To reset the system to the factory settings:
–
Click Reset.
–
Accept the EULA (End User License Agreement).
DiBos starts with the English user interface.
Installation Guide
DiBos 8 Recovery
Bosch Sicherheitssysteme GmbH
Advertisement
