1080I/Psf; Film Cadence - Sony BVM-E250 Operation Manual

Menu

1080I/PsF

24PsF
25PsF/50I
30PsF/60I

Film Cadence

Copy From
Other CH
Other Monitor
Monitor ID
Memory Stick
54
Channel Configuration Menu
Function and operation ([
When the 1080i/PsF signal is input, select the display mode.
You can select when Format is set to 3G/HD/SD-SDI Auto, HD/SD-SDI Auto, 4:2:2 YCbCr
10bit, 4:4:4 YCbCr 10bit, 4:4:4 RGB 10bit, 4:4:4 YCbCr 12bit, 4:4:4 RGB 12bit, 4:4:4 XYZ
12bit, Component YPbPr or Component RGB.
When 1080I is selected, the I/P conversion signal is displayed. When 1080PsF is selected,
the progressive conversion (PsF to P) signal is displayed.
When the 1080PsF signal is input and 1080I is selected, the display delay is shortened. The
signal converted from PsF to P is not displayed and the I/P conversion signal is displayed.
When Format is set to 3G/HD/SD-SDI Auto and Payload ID data are superimposed on the
SDI signal, 1080i/PsF processing is performed based on the Payload ID data, regardless of
the setting value.
Sets the display mode for the 1080/24PsF signal.
You can select from 1080I or [1080PsF].
Sets the display mode for the 1080/25PsF, 50i signal.
You can select from [1080I] or 1080PsF.
Sets the display mode for the 1080/30PsF, 60i signal.
You can select from [1080I] or 1080PsF.
Sets the film cadence mode.
The progressive conversion signal is displayed according to the setting.
[Off]: The progressive conversion signal is not displayed in film cadence mode.
2-2: The progressive conversion signal is displayed when the interlace signal of 2-2 pull-
down processing is input
2-3: The progressive conversion signal is displayed when the interlace signal of 2-3 pull-
down processing is input
2-3-3-2: The progressive conversion signal is displayed when the interlace signal of 2-3-
3-2 pull-down processing is input
Notes
• When the 50i interlace signal is input, the mode is automatically set to 2-2, even when 2-3
or 2-3-3-2 is selected.
• The signal is not displayed in film cadence mode when 1080i interlace signal is input and
1080PsF is selected in the 1080I/PsF menu. Set to 1080I.
• As the signal is displayed in film cadence mode by cadence sequence detection based on
the pattern of the input signal, the signal may not be displayed correctly, because of the
pattern of the input signal.
• The signal is not displayed in the film cadence mode when Side by Side, Wipe, Butterfly or
Blending is set to On.
Copies signal setting data from other channel.
Note
Use the controller with software version 1.6 or higher to use the Copy From function.
Copies other data in this monitor.
When the item is selected, you can designate the channel to be copied.
Copies data from other monitor.
Enters the ID number of the source monitor.
When the NETWORK switch is set to PEER TO PEER, this is not selectable.
When the item is selected, you can designate the source monitor.
When the ID number is entered, you can designate the channel to be copied.
Copies data in the "Memory Stick".
When the item is selected, the file names in the source "Memory Stick" are displayed.
When the file is selected, you can enter the channel number in the selected file.
]: factory setting)