Setup Problems - HP Mp3130 - Digital Projector XGA DLP User Manual

Fixing the System
If the projector's network configuration is completely wrong and you cannot
fix it:

Setup problems

If you cannot change settings using a Web browser:
If you cannot install Wireless Presenter-to-Go on your computer:
56
an Infrastructure connection. For more details, see Chapter 2,
"Presenting from a Networked Computer," on page 17 or Chapter
3, "Presenting from a Wireless Handheld Organizer," on page 29.
❏
Reset the projector's network configuration to the factory default
values. To do this, turn off the projector, allow it to cool, then
unplug the power cord. Then insert a straightened paperclip into
the small hole on the module below the audio port. While
pressing the small button inside, plug in the power cord and
continue holding the button for at least 15 seconds.
❏
Contact your network administrator to determine the proper
settings for your network.
❏
If you cannot connect to the projector using a Web browser, see
the previous problem above.
❏
If you cannot access or edit certain pages, the Web interface
has been protected by the Web administrator. Contact the
administrator.
❏
If the administrator password has been forgotten, reset the
network configuration to the factory default values. See the
previous problem above.
❏
Be sure your computer meets the minimum requirements for
Wireless Presenter-to-Go. See "To prepare your computer for
networked presentations" on page 18 for more information.
❏
If an earlier version of HP Wireless Presenter-to-Go is installed
on your computer, try uninstalling it before installing a new
version.
User's Guide