HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual page 3

3. Once at the NetServer Navigator Main Menu, verify information in top right corner
of the screen, and then select Diskette Library.
4. Select the desired driver. Once the desired driver is highlighted, insert a blank
formatted 1.44 MB floppy diskette into the floppy drive and select Create
Diskette(s). (Manual installation requires NOS Drivers diskette).
5. Repeat step 4 until all desired driver diskettes are created.
6. Select the Exit icon located in the bottom left hand corner of the screen after all
driver diskettes have been created.
Installing the IDE CD-ROM Drive with FDATACD.SYS and
MSCDEX.EXE
To install Netware 4.2, you must first install a CD-ROM drive and driver in the DOS
environment by using the driver diskettes you created using the HP NetServer Navigator
CD.
NOTE: DOS CD-ROM drivers are available on the NOS Drivers Diskette in the
\Cdromdrv\IDEDOS directory.
1. Boot your HP NetServer using an MS DOS bootable utility diskette.
2. Use the fdisk utility to create a 250 MB primary DOS partition on the primary
drive(C:). Remember to set the partition to active.
3. Use the format utility to format 250 MB partition.
4. Install DOS. (For detail instruction, see the instructions in the NetWare
documentation.)
NOTE: If applicable, make sure to remark the DOS=HIGH and the
DEVICE=C:\DOS\HIMEM.SYS lines in the CONFIG.SYS file by inserting the
command REM at the beginning of each line (i.e., REM DOS=HIGH). Otherwise
NetWare may not function properly.
5. Insert the NOS Drivers Diskette created from the Navigator CD into the 1.44 MB
floppy drive (A:).
6. Create a subdirectory on drive C by entering the command:
MD directoryname
where directoryname is a valid name for a directory (for example: doscdrom).
7. Copy all DOS CDROM drivers from drive A to this subdirectory, by entering the
command: